It means the parallel port is already taken by the lp module. : 00000000īut if you get instead Failed to open /dev/parport0: Permission denied *** Found a AMD 29lv320MB 2Mx16 BotB (4MB) Flash Chip ***
Probing Flash at (Flash Window: 0x1fc00000). *** Found a Broadcom BCM6348 Rev 1 CPU chip *** If the flash memory is detected correctly you should get = The interface I have built is the unbuffered version which is the simplest, here the schematic I found on the net:Ĭheck if the interface is working: sudo. I tried also to upload the CFE image using my JLink JTAG interface without success. Note that the eJTAG is different from the standard JTAG. Solder a header connector 6+6 located at J201 (add pic) and connect the eJTAG interface. – the Telsey MAGIC EJTAG Debrick Utility application.– the CFE binary image called CFE.BIN (remember to make it before flashing new firmware images).– an eJTAG interface (like one of these ).To restore the original CFE bootloader you need:
This happens when I add too much stuff in the OpenWrt configuration before compiling. I occasionally brick my Netgear DG834GT when I try to flash an image bigger than its flash size and unfortunately the CFE bootloader has not any size check before flashing. How to restore the Netgear DG834GT CFE bootloader (unbrick)
0 kommentar(er)
